Welcome to Anagrammer Crossword Genius! Keep reading below to see if vimeter is an answer to any crossword puzzle or word game (Scrabble, Words With Friends etc). Scroll down to see all the info we have compiled on vimeter.
vimeter
Searching in Crosswords ...
The answer VIMETER has 0 possible clue(s) in existing crosswords.
Searching in Word Games ...
The word VIMETER is NOT valid in any word game. (Sorry, you cannot play VIMETER in Scrabble, Words With Friends etc)
There are 7 letters in VIMETER ( E1I1M3R1T1V4 )
To search all scrabble anagrams of VIMETER, to go: VIMETER
Rearrange the letters in VIMETER and see some winning combinations
Scrabble results that can be created with an extra letter added to VIMETER
4 letters out of VIMETER
Searching in Dictionaries ...
Definitions of vimeter in various dictionaries:
No definitions found
Word Research / Anagrams and more ...
Keep reading for additional results and analysis below.
| Vimeter might refer to |
|---|
|
A volume unit (VU) meter or standard volume indicator (SVI) is a device displaying a representation of the signal level in audio equipment. The Acoustical Society of America standardized it in 1942 (ANSI C16.5-1942) for use in telephone installation and radio broadcast stations. Consumer audio equipment often features VU meters, both for utility purposes (e.g. in recording equipment) and for aesthetics (in playback devices).* The original VU meter is a passive electromechanical device, namely a 200 µA DC d'Arsonval movement ammeter fed from a full wave copper-oxide rectifier mounted within the meter case. The mass of the needle causes a relatively slow response, which in effect integrates the signal, with a rise time of 300 ms. 0 VU is equal to +4 dBu, or 1.228 volts RMS, a power of about 2.5 milliwatts when applied across a 600 ohm load. 0 VU is often referred to as "0 dB". The meter was designed not to measure the signal, but to let users aim the signal level to a target level of 0 VU (sometimes labelled 100%), so it is not important that the device is non-linear and imprecise for low levels. In effect, the scale ranges from −20 VU to +3 VU, with −3 VU right in the middle. Purely electronic devices may emulate the response of the needle; they are VU-meters in as much as they respect the standard. * The VU-meter (intentionally) "slows" measurement, averaging out peaks and troughs of short duration, and reflects more the perceived loudness of the material than the more modern and initially more expensive PPM meters. For this reason many audio practitioners prefer it to its alternatives, though the meter indication does not reflect some of the key features of the signal, most notably its peak level, which in many cases, must not pass a defined limit. * In the broadcast industry, loudness monitoring was standardized, in 2009 in the United States by the ATSC A/85, in 2010 in Europe by the EBU R-128, in 2011 in Japan by the TR-B32, and in 2010 in Australia by the OP-59. * * |