Welcome to Anagrammer Crossword Genius! Keep reading below to see if slittie is an answer to any crossword puzzle or word game (Scrabble, Words With Friends etc). Scroll down to see all the info we have compiled on slittie.
slittie
Searching in Crosswords ...
The answer SLITTIE has 0 possible clue(s) in existing crosswords.
Searching in Word Games ...
The word SLITTIE is NOT valid in any word game. (Sorry, you cannot play SLITTIE in Scrabble, Words With Friends etc)
There are 7 letters in SLITTIE ( E1I1L1S1T1 )
To search all scrabble anagrams of SLITTIE, to go: SLITTIE?
Rearrange the letters in SLITTIE and see some winning combinations
Scrabble results that can be created with an extra letter added to SLITTIE
7 letters out of SLITTIE
6 letters out of SLITTIE
4 letters out of SLITTIE
Searching in Dictionaries ...
Definitions of slittie in various dictionaries:
No definitions found
Word Research / Anagrams and more ...
Keep reading for additional results and analysis below.
Slittie might refer to |
---|
The slitting mill was a watermill for slitting bars of iron into rods. The rods then were passed to nailers who made the rods into nails, by giving them a point and head. * The slitting mill was probably invented near Liège in what is now Belgium. The first slitting mill in England was built at Dartford, Kent in 1590. This was followed by one on Cannock Chase by about 1611, and then Hyde Mill in Kinver in 1627. Others followed in various parts of England where iron was made. However there was a particular concentration of them on the River Stour between Stourbridge and Stourport, where they were conveniently placed to slit iron that was brought up (or down) the River Severn before it reached nailers in the Black Country. * The slitting mill consisted of two pairs of rollers turned by water wheels. Mill bars were flat bars of iron about three inches (75 mm) wide and half an inch (13 mm) thick. A piece was cut off the end of the bar with shears powered by one of the water wheels and heated in a furnace. This was then passed between flat rollers which made it into a thick plate. it was then passed through the second rollers (known as cutters), which slit it into rods. The cutters had intersecting grooves which sheared the iron lengthways. |