Welcome to Anagrammer Crossword Genius! Keep reading below to see if slitti is an answer to any crossword puzzle or word game (Scrabble, Words With Friends etc). Scroll down to see all the info we have compiled on slitti.
slitti
Searching in Crosswords ...
The answer SLITTI has 0 possible clue(s) in existing crosswords.
Searching in Word Games ...
The word SLITTI is NOT valid in any word game. (Sorry, you cannot play SLITTI in Scrabble, Words With Friends etc)
There are 6 letters in SLITTI ( I1L1S1T1 )
To search all scrabble anagrams of SLITTI, to go: SLITTI?
Rearrange the letters in SLITTI and see some winning combinations
Searching in Dictionaries ...
Definitions of slitti in various dictionaries:
SLITTI - The slitting mill was a watermill for slitting bars of iron into rods. The rods then were passed to nailers who made the rods into nails, by giving ...
Word Research / Anagrams and more ...
Keep reading for additional results and analysis below.
Slitti might refer to |
---|
The slitting mill was a watermill for slitting bars of iron into rods. The rods then were passed to nailers who made the rods into nails, by giving them a point and head. * The slitting mill was probably invented near Liège in what is now Belgium. The first slitting mill in England was built at Dartford, Kent in 1590. This was followed by one on Cannock Chase by about 1611, and then Hyde Mill in Kinver in 1627. Others followed in various parts of England where iron was made. However there was a particular concentration of them on the River Stour between Stourbridge and Stourport, where they were conveniently placed to slit iron that was brought up (or down) the River Severn before it reached nailers in the Black Country. * The slitting mill consisted of two pairs of rollers turned by water wheels. Mill bars were flat bars of iron about three inches (75 mm) wide and half an inch (13 mm) thick. A piece was cut off the end of the bar with shears powered by one of the water wheels and heated in a furnace. This was then passed between flat rollers which made it into a thick plate. it was then passed through the second rollers (known as cutters), which slit it into rods. The cutters had intersecting grooves which sheared the iron lengthways. |